Then, pin together the edges between the two Corner Points. Place the pins exactly through the Corner Point of both pieces, lining them up as perfectly as you can. Here’s how…įirst, pin the pieces together at the two Corner Points. With right sides together, pin these two pieces along Piece A’s bottom left edge and Piece B’s top edge. #Falling blocks quilt pattern download fullPiece C has the stripes running from upper right to lower right, with the acute angles at the upper right and lower left.īegin the Full Tumbling Block by sewing together a Piece A and a Piece B.Piece B has the stripes running straight up and down with the acute angles at the upper left and lower right.Piece A has the stripes running from upper left to lower right, with the acute angles at the left and right.The pieces are identical, but you spin them in three different orientations when you sew them together. Piece the Full Tumbling BlocksĮach Full Tumbling Block is made from 3 pieces. The center of each of these X’s is a Corner Point. You will be left with four “X” marks, one at each corner. Line the Quilt and Sew Ruler ¼ inch from and parallel to a straight edge of a piece, and make an approximately ½-inch mark at both the corners. Markįlip the pieces over so the right side of the fabric is facing up. Repeat these instructions to cut 108 pieces. Unfold the resulting triangle, and you’ll see that this piece is actually an equilateral parallelogram (aka a rhombus)! Press the piece flat. Use the rotary cutter to cut along the right-hand side of the ruler. Again orient it so that the 60-degree mark of the rotary cutting ruler runs along the bottom edge of the strip, as shown above. Place the ruler along the left-hand edge of this triangle. Finger press this equilateral 60-degree triangle in place. Discard the corner piece of fabric, or save it for another purpose.įold the cut end of the strip upwards until it meets the top edge of the strip. The 60-degree mark of the rotary cutting ruler should run along the bottom edge of the strip, creating a 60-degree angle between the bottom edge and the right-hand side of the ruler. Orient the strip so that the long edges run along the top and bottom and the wrong side of the fabric is facing up.Īt the bottom right corner, use the markings on your rotary cutting ruler to measure a 60-degree angle. Cut it so that the stripes are parallel to the long edges of the strip. With the wrong side of the fabric facing up cut a 54 x 4 ¼-inch strip. Each piece is a parallelogram with two 60-degreee corners, two 120-degree corners, and four 5 ¼-inch sides. Put this aside until the “Baste” section. If you’re new to rotary cutting, please refer to our Rotary Cutting Tutorial before you start. If you are using a fabric without a clear right or wrong side, as we are here, just choose either side as the right side. Prewash, dry, and press all of the fabric (but not the batting) before beginning.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |